Wheel bearings and seals
Suzuki DR350 motorcycles, 1990 - 1999.
Created:
Updated:
// //
Buy O-rings for your DR350. Good quality + low prices.
When sourcing replacement bearings, I like to use bearings that are sealed on both sides. This does not eliminate the need for additional seals.
Front wheel bearings and seals for 1990 - 1996 Suzuki DR350 models, 1990 - 1996 Suzuki DR350 S models, and 1997 Suzuki DR350 SE models
- 6202: 15 mm ID × 35 mm OD × 11 mm width (1 of these bearings is required) SPN# 08113-62027 (right side - physical size is the same, integrated seal differs)
- 6202: 15 mm ID × 35 mm OD × 11 mm width (1 of these bearings is required) SPN# 08123-62027 (left side - physical size is the same, integrated seal differs)
- Seal: 22 mm ID × 35 mm OD × 5 mm width (1 of these seals is required - brake caliper side only) SPN# 09284-22004
Front wheel bearings and seals for 1997 - 1999 Suzuki DR350 models and 1998 - 1999 Suzuki DR350 SE models
- 6003: 17 mm ID × 35 mm OD × 10 mm width (2 of these bearings are required) SPN# 08123-60037
- Seal: 23 mm ID × 35 mm OD × 6 mm width (1 of these seals is required - brake caliper side only) SPN# 09284-23001
Rear wheel bearings and seals for 1990 - 1999 Suzuki DR350 models, 1996 Suzuki DR350 S models, and 1997 - 1999 DR350 SE models (no cush drive)
- 6004: 20 mm ID × 42 mm OD × 12 mm width (2 of these bearings are required) SPN# 08133-60047
- 6204: 20 mm ID × 47 mm OD × 14 mm width (1 of these bearings is required) SPN# 08123-62047
- Seal: 26 mm ID × 42 mm OD × 8 mm width (1 of these seals is required) SPN# 09282-26001
- Seal: 26 mm ID × 47 mm OD × 5 mm width (1 of these seals is required) SPN# 09283-26019
Rear wheel bearings and seals for 1990 - 1995 Suzuki DR350 S models (cush drive)
Thanks to Thump!
for posting this infromation on the Adventure Rider forum.
- 6204: 20 mm ID × 47 mm OD × 14 mm width (2 of these bearings are required) SPN# 08123-62047
- 6205: 25 mm ID × 52 mm OD × 15 mm width (1 of these bearings is required) SPN# 09262-25061
- Seal: 26 mm ID × 47 mm OD × 5 mm width (1 of these seals is required) SPN# 09283-26019
- Seal: 34 mm ID × 52 mm OD × 6 mm width (1 of these seals is required) SPN# 09283-34003