Right handlebar switch

Right handlebar switch

Ready to solder to your switch. Works with switch pictured below (not included).

NOTE: The official Moto Guzzi 750 S spare parts catalog lists MG# 12750301 as the part number for this 750 S sub-harness. The one I sell here is a duplicate of the sub-harness used by the V7 Sport. I am not aware of the differences between MG# 12750300 and MG# 12750301. I believe the V7 Sport sub-harness will work perfectly on the 750 S. If you know otherwise or have any trouble after purchase, I will work with you to correct any issues.

IMPORTANT NOTE: It is very easy to destroy original or aftermarket switches when using a conventional soldering iron. Even if you know exactly what you are doing and are very experienced with soldering procedures, the switches can very easily be rendered useless. Rather than using solder, I strongly recommend the following:

• Use a conductive epoxy to secure the wires to the switch. Most epoxies, including JB Weld, do not conduct electricity. MG Chemicals makes a conductive epoxy that I've used with excellent results (part number 8331D). Atom Adehesives AA-PROD 123 is a less expensive epoxy that Charlie Mullendore of Antietam Classic Cycle reports works well. Nick Rossi contacted Atom Adhesives directly and found that AA-Duct 902 is the most conductive epoxy and that AA-Duct 916 is more suitable for motorcycle applications as it is flexible once cured and will be more resistant to vibration. Nick prefers the AA-Duct 916 (available from Amazon).